Fig. 4
Scanning electron microscopy (SEM) images
of an area of unworn manufactured taper surface (left) and an area
deeper in the same taper that shows the imprint of the machining
grooves of the trunnion (right). Note: images are at the same level of
magnification.
| BJRES
Figure
Taper junction failure in large-diameter metal-on-metal bearings
Related content
Related content
BJR / Hip
-
Flow chart showing participation (OHS,
Oxford hip score; HOOS, Hip dysfunction and Osteoarthritis Outcome
Score; SF-12, ...
Fig. 1
-
Bar chart showing the skew of distribution
of the Oxford hip score (OHS).
Fig. 2
-
Graphic outputs for the assessment
of polyethylene wear, a) using model-based radiostereometric analysis
(MB-RSA), showi...
Figs. 3a - 3c
-
Bland-Altman plots of precision (repeatability)
with 95% limits of agreement (bias with 95% repeatability limits
(1.96 Ã...
Fig. 4
-
Bland-Altman plots with 95% limits of
agreement (bias ± 1.96) comparing two- (2D) and three-dimensional
(3D) wear measu...
Fig. 5
-
Bland-Altman plots of accuracy with
95% limits of agreement (bias ± 1.96) (the closeness of agreement
between measured ...
Fig. 6
-
Regression lines (best fit lines) for
accuracy of two- (2D) and three-dimensional (3D) wear by method
after a sensitivit...
Fig. 7
-
Photograph showing the phantom
fixture with a Bi-Metric hip system that was used to simulate the
displacement of the fem...
Fig. 1
-
Photograph showing the stereo radiological
setup with two synchronised ceiling-fixed roentgen tubes, the hip
phantom on ...
Fig. 2